Siemens VersiCharge 8EM1310-F.0 Series Operating Instructions Manual page 35

Procedure
Risk of electric shock
When connecting the Wallbox, pay attention to the five safety rules (see also The five safety
rules for electrical work (Page 13)).
To connect the supply cable, proceed as follows:
1. Insert the supply cable through the cable entry and connect the supply cable.
NOTE
Wire end sleeves when using stranded cables
When connecting stranded cables, use wire end sleeves.
NOTE
Ferrite core in 3-phase models
For 3-phase models, install the enclosed ferrite core around the PE cable as follows:
– Measure and mark 46 cm on the PE cable.
– Feed the PE cable through the ferrite core up to the marking.
– Wind the PE cable around the ferrite core only 4 times.
– Connect the PE cable to the terminal block.
– Place the ferrite core in the Wallbox.
VersiCharge AC Wallbox Operating Instructions ERK
Operating Instructions, 08/2023, A5E51549696-AC
DANGER
Mounting / Installing / Connecting
4.6 Connecting the supply cable
35