Siemens SIMATIC RF1000 Operating Instructions Manual page 76

Demo application
8.2 Creating a custom application
Figure 8-4
Own application "Transfer reader configuration"
Requirement: A corresponding VHL configuration was created and transferred to a
configuration card.
Follow the steps below to transfer a reader configuration using a configuration card:
1. Establish the connection to the reader ("brp_open_usb_session" or
"brp_open_serial_session").
2. Check whether a configuration card is located in the read range of the reader ("vhl_select";
"AllowConfig = true").
If a configuration card is located in the read range, the status code "CONFIG_READ" or
"HF_ERR" is returned and the configuration is transferred to the reader. Parameterization is
complete as soon as "vhl_select = STATUS_OK" is returned.
3. Terminate the connection to the reader ("brp_close_session").
4. Establish the connection to the reader again ("brp_open_usb_session").
The source code of the demo application can serve as an example for your own application.
76
"Read/write memory area" flow diagram
Operating Instructions, 05/2023, C79000-G8976-C432-10
SIMATIC RF1000