Siemens SIMATIC RF1000 Operating Instructions Manual page 18

Installation
NOTICE
Using the reader in a cleanroom
Note that when operating the reader in a cleanroom, the cleanroom cover must be installed
and the reader or the table/wall housing must be sealed with a silicone joint.
Recommendations for the silicone joint:
• Silicone recommended for cleanroom: Silirub Cleanroom
• Radius of the joint tool for wiping: 5 mm
NOTICE
Repair and maintenance
Do not try to repair the reader in case of a problem. Repair and maintenance work must only
be carried out by qualified personnel. Contact Siemens Support in case of repair or
maintenance problems. For more information, refer to the section "Service & Support".
Required tools
The following tool is required:
• Torx screwdriver (T10)
• Slotted screwdriver
• If necessary, caulking gun, silicone cartridge and joint tool (relevant for operation in a
cleanroom)
Accessories required
Depending on the type of installation, you may require the following accessories to install the
reader:
• for in-wall or cabinet installation
– If necessary, card holder "6GT2890-0CA00" or
– If necessary, cleanroom cover cabinet installation "6GT2890-0CD00" (relevant for
• for surface or table installation
– table/wall housing "6GT2890-0CB00"
– 4x screws (∅ 4 mm) and matching anchors
– If necessary, card holder "6GT2890-0CA00" or
– If necessary, cleanroom cover surface installation "6GT2890-0CC00" (relevant for
18
operation in a cleanroom)
operation in a cleanroom)
Operating Instructions, 05/2023, C79000-G8976-C432-10
SIMATIC RF1000