Siemens SIMATIC RF1000 Operating Instructions Manual page 15

AWID
ioProx
✓: Reading the serial number as well as reading and writing the user memory area
Transponder card must be formatted.
1)
An identification card is required to access encrypted user memory areas (see section
2)
"Commissioning").
Only for read access. Write access to the user memory area is not possible.
3)
The license must be transferred to the reader with a license card (HID).
4)
In addition to the specified protocols and card types, a variety of transponder cards are
generally supported by the readers. If you cannot find the card type that you use in the table,
you can ask Siemens Customer Support about the functionality.
Note that serial numbers (UIDs) of transponders that begin with the byte "0x08" are
always newly generated by the transponder. This makes an assignment of serial numbers
and transponders impossible. For transponders with a combo-chip (e.g. LEGIC CTC4096),
the serial number of the LEGIC Prime chip is always read and not that of the ISO chip
14443/15693. For transponders with two integrated chips (125 kHz / 13.56 MHz), you must
ensure which chip is addressed via the reader configuration.
SIMATIC RF1000 readers can also recognize multiple transponders that are simultaneously
located in the antenna field. You can find information on selecting multiple transponders in
the section "vhl_select (Page 43)".
The reader can be addressed and controlled by functions, for example to change the status of
the reader or to communicate with a transponder. With the aid of the functions, you can for
example control the three-color reader LED. The functions and their calls are described in this
manual.
SIMATIC RF1000
Operating Instructions, 05/2023, C79000-G8976-C432-10
3.2 Connection options and supported transponders
SIMATIC RF1040R SIMATIC RF1060R
Serial number
Serial number
Description
SIMATIC RF1070R
-- --
-- --
15