Syscmd_Set_Port - Siemens SIMATIC RF1000 Operating Instructions Manual

Byte
3 ... 4
5
Table 7-27
Byte
0
1
2
3
4
5 ... 8
9
7.3.2.4

syscmd_set_port

Max. reader response time: 100 ms
Table 7-28
Byte
0
1
2
3
4
5
6
7
SIMATIC RF1000
Operating Instructions, 05/2023, C79000-G8976-C432-10
7.3 Programming via the RS232 interface (using the Freeport protocol)
Value Description
0x00 Parameter length (0 bytes)
0xC4 Optional checksum (when the value "0x1C" is set in byte 0)
Response telegram without errors
Value Description
0x0C Without checksum
0x1C With checksum
0x00 DevCode of the command set containing the command to be called.
0x05 CmdCode of the command to be called.
0x04 Parameter length (4 bytes)
0x00
0x00 Boot status = 0x00 (OK)
0x48 Optional checksum (when the value "0x1C" is set in byte 0)
Request telegram
Value Description
0x0C Without checksum
0x1C With checksum
0x00 DevCode of the command set containing the command to be called.
0x07 CmdCode of the command to be called.
0x02 Parameter length (2 bytes)
0x00
0x00 port_msk:
0xXX • 0x00: LED and acoustic signal
• 0x01: LED lit green
• 0x02: LED lit red
• 0x03: LED lit orange
• 0x04: Acoustic signal (only for RF1040R/RF1070R)
• 0x05: Acoustic signal (only for RF1040R/RF1070R) and LED lit green
• 0x06: Acoustic signal (only for RF1040R/RF1070R) and LED lit red
• 0x07: Acoustic signal (only for RF1040R/RF1070R) and LED lit orange
0xXX Optional checksum (when the value "0x1C" is set in byte 0)
Programming
57