Introduction - Siemens SIMATIC RF1000 Operating Instructions Manual

Introduction

Purpose of this document
This documentation provides you with an overview of the installation and programming of the
SIMATIC RF1040R, RF1060R and RF1070R readers. The operating instructions are intended for
users and programmers involved in configuration, commissioning and servicing of SIMATIC
RF1000 readers.
Basic knowledge required
These operating instructions assume general knowledge of automation engineering and
identification systems.
Scope of validity of this documentation
These operating instructions are valid for the SIMATIC RF1040R (6GT2831-6CA60), RF1060R
(6GT2831-6AA60) and RF1070R (6GT2831-6BA60) from firmware version V2.03.05, as well as
for SIMATIC RF1040R (6GT2831-6CA50), RF1060R (6GT2831-6AA50) and RF1070R
(6GT2831-6BA50) from firmware version V2.0.7 and describe the delivery status as of 05/2023.
NOTICE
The scope of functions depends on the specific reader
Please note that all Bluetooth (BLE) and license card (HID license) contents mentioned in this
manual are valid only for the new devices with article numbers "6GT2831-6xA60".
Registered trademarks
The following and possibly other names not identified by the registered trademark sign
registered trademarks of Siemens AG:
SIMATIC ®, SIMATIC RF ® and MOBY ®
Orientation in the documentation
Detailed information on creating and customizing configurations as well as their transfer to the
SIMATIC RF1000 reader is available in the configuration manual "SIMATIC RF1000
support.industry.siemens.com/cs/ww/en/ps/24224/man)".
The manuals of the relevant SIMATIC Ident products (e.g. SIMATIC RF170C) on the
Siemens Industry Online Support
man) pages contain additional information on the devices specified in this document.
SIMATIC RF1000
Operating Instructions, 05/2023, C79000-G8976-C432-10
(https://support.industry.siemens.com/cs/ww/en/ps/14970/
1
® are
(https://
5