Ip Igmp Snooping Version - SMC Networks TigerSwitch SMC8612T2 Management Manual

Command Mode
Global Configuration
Example
The following shows how to statically configure a multicast group on a
port.
Console(config)#ip igmp snooping vlan 1 static 224.0.0.12 ethernet 1/5
Console(config)#

ip igmp snooping version

This command configures the IGMP snooping version. Use the no form
to restore the default.
Syntax
ip igmp snooping version {1 | 2}
no ip igmp snooping version
• 1 - IGMP Version 1
• 2 - IGMP Version 2
Default Setting
IGMP Version 2
Command Mode
Global Configuration
Command Usage
• All systems on the subnet must support the same version. If there are
legacy devices in your network that only support Version 1, you will
also have to configure this switch to use Version 1.
• Some commands are only enabled for IGMPv2, including ip igmp
query-max-response-time and ip igmp query-timeout.
Example
The following configures the switch to use IGMP Version 1:
Console(config)#ip igmp snooping version 1
Console(config)#
M F
ULTICAST ILTERING
C
OMMANDS
4-273