Spanning-Tree Port-Priority - SMC Networks TigerSwitch SMC8612T2 Management Manual

• When the spanning-tree pathcost method (page -213) is set to short,
the maximum value for path cost is 65,535.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree cost 50
Console(config-if)#

spanning-tree port-priority

This command configures the priority for the specified interface. Use the
no form to restore the default.
Syntax
spanning-tree port-priority priority
no spanning-tree port-priority priority
priority - The priority for a port. (Range: 0-240, in steps of 16)
Default Setting
128
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This command defines the priority for the use of a port in the
Spanning Tree Algorithm. If the path cost for all ports on a switch are
the same, the port with the highest priority (that is, lowest value) will
be configured as an active link in the spanning tree.
• Where more than one port is assigned the highest priority, the port
with lowest numeric identifier will be enabled.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree port-priority 0
Console(config-if)#
Related Commands
spanning-tree cost (4 -220)
S T
PANNING REE
C
OMMANDS
4-221