Connecting 12-Volt Trigger Output To External Theater Equipment; Turning On The Power - Runco RS 440LT/CineWide User Manual

If your home theater contains a retractable screen, screen mask or other 12-volt
trigger-activated equipment, connect it to the 12-volt trigger output as shown in Figure
3-14.
3.5-mm
mini plug
Black = Ground (Sleeve)
Red = +12V (Tip)
Figure 3-14. Connecting the 12-Volt Trigger Output to Other Equipment
1. Turn on your source components.
2. Plug the female end of the power cord into the
AC receptacle on the rear of the RS-440 (AC
100V ~ 240V). (The RS-440 ships with various
types of AC power cords. Choose the one that
is appropriate to your locale.)
3. Connect the other end to your AC power
source. The power indicator lights blue to
indicate that the RS-440 is in "standby" mode.
4. Press the ON button on the remote control to
turn on the projector. The power indicator
turns off.
5. After a brief warm-up period (approximately 10 seconds), the RS-440 will start
projecting.
Runco RS-440 Installation/Operation Manual
Retractable Screen
or other, 12-volt
trigger-activated equipment
29
Installation
Connecting 12-Volt
Trigger Output to External
Theater Equipment
3.7

Turning on the Power