Installation - Runco RS 440LT/CineWide User Manual

To access the Installation adjustments, press MENU, then press the
highlight Installation and press ENTER. The Installation sub-menu appears. Press EXIT to
return to the previous menu or press MENU to close all menus.
When you change a setting in the Installation menu, the change takes
Note
effect immediately; you do not need to press ENTER afterwards.
(Press EXIT to return to the previous menu or MENU to exit.)
Language: Select Language from the Installation menu and press ENTER. Then, use the
or button to select from the available languages: English, French, Spanish, German
and Italian.
Orientation: Select Orientation from the Installation menu and press ENTER. Then, use
the or button to change the orientation of the projected image. The RS-440 can be
installed on a ceiling or in a rear-screen configuration with one or more mirrors. There are
four settings: Floor Front, Ceiling Front, Floor Rear and Ceiling Rear.
Keystone: Projector placement and other factors can cause geometric distortion in the
projected image. To correct this, select Keystone from the Installation menu. This
sub-menu provides the following options:
• V. Keystone/H. Keystone: To correct distortion resulting from the angle of projection,
select V. Keystone or H. Keystone from the Keystone menu and use the
to make the image rectangular. See Figure 4-6.
Runco recommends that the keystone feature not be used unless
Tip
absolutely necessary, as it may cause artifacts in the image.
1. The RS-440 keystone correction can compensate for up to
Note
approximately 15 degrees of screen and/or projector tilt.
2. Straight lines or the edges of images may appear jagged while
adjusting the image.
Runco RS-440 Installation/Operation Manual
or button to
or button
47
Operation

Installation

Installation
Language
Orientation
Keystone
Overscan
YUV/RGB Adjust
OSD Timeout
Vertical Correction
V. Keystone
H. Keystone
0
0