Other Considerations; Installing The Optional Cinewide Lens Base Plate - Runco RS 440LT/CineWide User Manual

Installation

Other Considerations

3.4
Installing the Optional
CineWide Lens Base
Plate
➤
Other considerations and tips that can help improve your installation:
• Keep the ambient temperature constant and below 35°C (95°F). Keep the projector
away from heating and/or air conditioning vents. Changes in temperature may cause
drifts in the projector circuitry, which may affect performance.
• Keep the projector away from devices that radiate electromagnetic energy such as
motors and transformers. Common sources of these include slide projectors,
speakers, power amplifiers and elevators.
If you are installing an RS-440LT/CineWide, proceed as follows to install the CineWide
anamorphic lens base plate. Otherwise, skip this step and proceed with Mounting the
RS-440 (page 22).
Note
To install the fixed CineWide base plate on an RS-440LT/CineWide:
1. Place the projector upside down on a blanket or other soft surface.
2. Line up the three mounting holes on the CineWide base plate with those on the
bottom of the projector.
3. If you are mounting the RS-440LT/CineWide on a ceiling: Line up the three holes
on the projector ceiling mounting plate (included with the projector ceiling mount kit)
with those on the bottom of the projector.
4. Secure the CineWide base plate (and ceiling mounting plate, if needed) to the
projector with the M4x14mm screws provided with the CineWide lens base plate. See
Figure 3-7.
Caution
1. Do not install the CineWide lens yet, only the fixed CineWide
base plate. You will install the CineWide lens after you install the
projector and adjust the primary lens.
2. Some components shipped with your projector may differ slightly
from what is shown in these instructions.
1. Do not use the mounting screws provided with the ceiling
mount kit. Use only the hardware provided with the CineWide
lens base plate.
2. DO NOT OVER-TIGHTEN THE SCREWS.
20 Runco RS-440 Installation/Operation Manual