Detaching The Reac Caps; Attaching The Reac Connector Covers; Connecting The Power Cord; Using The Power-Cord Clamp - Roland M-5000 Reference Manual

Placement and Setup

Detaching the REAC Caps

By default, the REAC ports are fitted with REAC caps. Remove
these REAC caps when you use the REAC ports. Be careful to not
lose the removed REAC caps so you can insert them again when
transporting or when the port(s) are not in use.

Attaching the REAC Connector Covers

When using commercially available Category 5e Ethernet cables,
attach the included REAC connector covers.
Memo
Remove the REAC connector covers when using EtherCon type
REAC cables (such as SC-W20F, SC-W100S, or W100S-R). Be
careful to keep removed REAC connector covers from becoming
lost.
16

Connecting the Power Cord

NOTE
Be sure to use the included power cord for connecting the
power supply.
1.
Connect the included power cord to the AC IN connector
on the rear panel.
Power cord
* The shape of the power cord's plug varies depending on the
country.

Using the Power-cord Clamp

Lower the power-cord clamp as shown in the figure to secure the
power cord's plug in place.
AC IN connnector