Table of Contents
Advertisement
Configuring the Printer for the Network
I
If you use NetWare, select the
NetWare frame type.
Select one of the items below if
necessary.
• Auto Select (Default)
• Ethernet 802.3
• Ethernet 802.2
• Ethernet II
• Ethernet SNAP
3
Note
❒ In most situations, use the de-
fault setting ("Auto Select").
When you select "Auto Select",
the frame type first detected by
the printer is adopted. If the net-
work can use more than two
frame types, the printer may fail
to select the correct frame type if
"Auto Select" is selected. In this
case, select the appropriate
frame type.
A Press { { { { T T T T } } } } or { { { { U U U U } } } } until the fol-
lowing message appears.
Network Setup:
Frame Type(NW)
B Press { { { { Enter #} } } } .
The current setting appears on
the panel display.
Network Setup:
*Auto Select
C Use { { { { T T T T } } } } or { { { { U U U U } } } } until the frame
type you want to use appears.
D Press { { { { Enter #} } } } .
J
Exit the setup menu to the avail-
able function settings.
A Press { { { { Escape} } } } .
B Press { { { { Escape} } } } .
66
K
If you want to confirm the print-
er's configuration, print a config-
uration page.
A Press { { { { Menu} } } } .
The following message appears
on the panel display.
Main Menu:
Sample Print
B Press { { { { T T T T } } } } or { { { { U U U U } } } } until the fol-
lowing message appears.
Main Menu:
List Print
C Press { { { { Enter #} } } } .
The following message appears
on the panel display.
List Print:
Config. Page
D Press { { { { Enter #} } } } .
The following message appears
on the panel display.
Config. Page:
Press Enter (#)
When printing a configuration
page, you can confirm the print-
er's configuration.
Advertisement
Table of Contents
