Table of Contents
Advertisement
Setting Up the Printer
D
Use a coin to remove the two
screws, and remove the cover.
Note
❒ The removed screws are re-
quired in step F.
❒ The removed cover is no longer
2
required.
E
Align the hard disk interface con-
nector over the printer interface
port, and push gently but firmly
on the hard disk until it is com-
pletely connected.
F
Fasten the two screws that were
removed in step D D D D to attach the
hard disk to the printer.
42
G
Attach the printer board cover
that was removed in step C C C C , and
use a coin to fasten the six screws.
Note
❒ After installing all options, print
a configuration page to confirm
the installation. If the new de-
ZDEP140E
vice is listed in the column of
configuration options, then it
has been properly installed. For
more information, see P.54
"Printing a Configuration Page".
ZDEP150E
ZDEP160E
ZDEP102E
Advertisement
Table of Contents
