Table of Contents
Advertisement
B Press { { { { Enter #} } } } .
Byte 1 of the IP address appears
on the panel display.
IP Address:
Byte 1= 11
C Use { { { { U U U U } } } } or { { { { T T T T } } } } to edit the val-
ue.
D Press { { { { Enter #} } } } .
Byte 2 of the IP address appears.
IP Address:
Byte 2= 22
E Use { { { { U U U U } } } } or { { { { T T T T } } } } to edit the val-
ue.
Repeat steps C and D to speci-
fy the remaining bytes.
F Press { { { { Enter #} } } } to register the IP
address you specified.
F
If you use TCP/IP, you should as-
sign the "Subnet Mask" and
"Gateway Address" using the
same procedure for specifying the
IP address.
G
If you use TCP/IP, set the "Access
Control" and "Access Mask" us-
ing the same procedure for speci-
fying the IP address, if necessary.
Configuring the Printer for the Network with the Operation Panel
H
If you use TCP/IP, you can make
settings for "Network Boot".
Choose how to obtain the printer's
IP address from a server on the
network. The following methods
are available.
Menu item on the
panel display
ARP + PING
ARP & RARP
ARP & BOOTP
ARP&RARP&BOOTP
None
(Default Setting)
RARP + TFTP
BOOTP
RARP & BOOTP
DHCP
*1
ARP + PING
*2
RARP + TFTP
*3
BOOTP
*4
DHCP
Note
❒ You must have configured the
server in order to use "RARP +
TFTP", "BOOTP", or "DHCP".
A Press { { { { T T T T } } } } or { { { { U U U U } } } } until the fol-
lowing message appears.
Network Setup:
Network Boot
B Press { { { { Enter #} } } } .
The current setting appears on
the panel display.
Network Boot:
*None
C Use { { { { T T T T } } } } or { { { { U U U U } } } } until the meth-
od you want to use appears.
D Press { { { { Enter #} } } } .
Available methods
AR
RA
BO
DH
*1
*2
*3
*4
'
'
'
'
'
'
'
'
'
'
'
'
'
3
65
Advertisement
Table of Contents
