Table of Contents
Advertisement
C
Remove the adhesive tape.
Important
❒ Do not remove the adhesive
tape holding the finisher and ca-
ble until the connector is at-
tached in step J.
D
Insert the output guide between
the printer and the bridge unit.
E
Mount the brackets of the finish-
er stand by placing them in the
printer, and then push it down-
wards slightly with catching it on
the projection of the output guide
(A A A A ).
F
Use a coin to fasten the screws,
and secure the finisher stand to
the printer
G
Hold the finisher with both
hands and keep it horizontal.
Align the holes of the finisher
ZDEP270E
over the brackets of the finisher
stand, and then push the finisher
downwards slightly.
Note
❒ If you do not keep the finisher
horizontal, you cannot install it
correctly. In this case, remove
the finisher and reinstall it. For
how to remove the finisher, see
the Printer Reference included
as a PDF file on the CD-ROM.
ZDEP290E
ZDEP300E
Installing Options
2
ZDEP301E
ZDEP310E
37
Advertisement
Table of Contents
