Table of Contents
Advertisement
Setting Up the Printer
H
Put your fingers inside the upper
cover of the printer and remove
the cover by pulling upward.
Note
❒ The upper cover of the printer is
no longer required.
2
I
Remove the interchange unit cov-
er from the interchange unit.
Note
❒ The removed cover is required
in step O.
J
Move the cable to the back of the
printer. Place the interchange unit
onto the printer as shown in the
illustration.
26
K
Open the upper right cover (A A A A )
and slide the interchange unit
while keeping the cover perpen-
dicular to the printer (B B B B ). At this
time, confirm that the projection
(C C C C ) is placed in the hole securely
as shown in the illustration.
ZAEP650E
L
Fasten the two screws with fin-
gers, while keeping the upper
right cover of the interchange unit
perpendicular to the printer, and
secure the interchange unit to the
printer. Use a coin to fasten the
screws.
ZAEP500E
M
Close the upper right cover of the
interchange unit.
ZAEP700E
90
ZAEP160J
ZAEP161E
ZAEP162E
Advertisement
Table of Contents
