Table of Contents
Advertisement
G
Mount the brackets of the holder
by placing them in the printer and
pushing downwards slightly.
H
Use the wrench to fasten the four
socket screws in the order as
shown in the illustration (A A A A - D D D D ),
to secure the holder to the printer.
Important
❒ The order to fasten the screws
is: top right, top left, bottom
right, and bottom left as viewed
from the right side of the print-
er. If the screws were not fas-
tened in that order, the duplex
unit might not close completely
or the bypass tray might not
work correctly.
I
Remove the small cover on the
right side of the printer.
Note
❒ The removed small cover is no
longer required.
ZAEP210E
J
Mount the brackets in the holes
in s ide of th e c over th at w as
opened in step I I I I . Use the wrench
to fasten the socket screw secur-
ing the hook to the printer.
K
Lower the duplex unit so that the
groove in each arm of the unit
forms a joint with the pin inside
the holder as shown in the illus-
tration.
ZAEP660E
Installing Options
2
ZAEP230E
ZAEP231E
ZAEP250E
29
Advertisement
Table of Contents
