Table of Contents
Advertisement
Setting Up the Printer
L
Hang the support bar in the du-
plex unit on to the hook that was
attached in step J J J J (A A A A ) and secure
the bar by attaching the hook
holder to the joint (B B B B ).
2
M
Close the duplex unit.
Note
❒ If the duplex unit is not closed
completely, the holder was not
installed properly in step H. Fas-
ten the socket screws securely in
the order described in step H.
N
Attach the connector of the du-
plex unit to the socket.
30
O
If the bypass tray is not installed,
attach the cover of the holder. Use
the wrench to fasten the two sock-
et screws in the order as shown in
the illustration to secure the hold-
er to the cover.
ZAEP260E
Note
❒ When installing the bypass tray,
the cover of the holder is not re-
quired.
❒ Keep the wrench in the wrench
house inside of the front cover.
ZAEP270E
❒ After installing all options, print
a configuration page to confirm
the installation. If the new de-
vice is listed in the column of
configuration options, then it
has been properly installed. For
more information, see P.54
"Printing a Configuration Page".
ZAEP280E
ZAEP220E
ZAEP540E
Advertisement
Table of Contents
