Surface mounting
The supplied mounting bracket can be used to mount your product horizontally or vertically on a
flat surface.
The Bulkhead bracket is not required for this type of installation.
Ensure that the chosen location meets the product's location requirements, see
a location
for details.
1. Using the supplied Mounting tray template (87170), drill 4 holes in the mounting surface, plus a
12 mm (
/
") hole for the SeaTalkng ® cable.
15
32
2. Place the small sealing ring in the groove located on the bottom of the mounting tray.
3. Secure the tray to the mounting surface using the 4 x fixings, supplied.
4. Place the large sealing ring into the groove on the upper side of the Mounting tray.
5. Pull the SeaTalkng ® cable through the mounting surface hole and the Mounting tray. Plug in the
cable connector on the underside of the unit and secure by rotating the locking collar clockwise 2
clicks.
6. Insert the unit into the mounting tray, ensuring the tabs in the Mounting tray are slotted into the
grooves around the edge of the unit.
Important:
The unit must be mounted with the LED 'arrow' on the top of the unit pointing towards the vessel's
bow and be in parallel alignment with the longitudinal axis (centerline) of your vessel.
6.1 Selecting