Surface Mounting - Raymarine ST5000+ Owner's Handbook Manual

40
Note: Adjacent control heads, or instruments, must have a 6 mm
(1/4 in) gap between them to allow sun covers to be fitted.

Surface mounting

To fit a surface mount control head:
1. Apply the surface mount template (supplied near the rear of this
2. Mark the centres of the two fixing holes and the cable boss.
3. Drill two 4 mm (5/32 in) diameter holes for the fixing studs.
4. Use a 90 mm (3.5 in) diameter cutter to drill the hole for the cable
5. Peel off the protective sheet from the self-adhesive gasket (4) then
6. Screw the fixing studs (2) into the display head.
7. Pass the cables (SeaTalk, power, compass etc.) through the
8. Assemble the control head to the bulkhead.
9. Secure the control head with the thumb nuts (3) provided. Tighten
ST5000 Plus Sterndrive & Hydraulic Autopilots Owner's Handbook
handbook) to the selected bulkhead.
1 4
boss (1).
stick the gasket into position on the rear of the control head bezel.
bulkhead and connect them to the appropriate terminals (see
relevant subsection for connection details).
the thumb nuts BY HAND. Do NOT use a wrench.
2 3
D3243-2