Installation; Surface Mounting The Ev-1; Bracket Mounting The Ev-1 - Raymarine EVOLUTION EV-1 Installation Instructions Manual

5.1 EV-1 Installation

Surface mounting the EV-1

The supplied Deck mounting kit is used to surface
mount the unit.
Ensure that the chosen location meets the product's
location requirements, see
for details.
Important:
The installation must only be performed with
the vessel either on a hard standing, or tied-up
alongside a pontoon or berth.
1. Using the Mounting tray template (87170), drill 4
holes in the mounting surface, plus a 22 mm (7/8
in) hole for the SeaTalkng® cable.
2. Place the small sealing ring in the groove located
on the bottom of the Mounting tray.
3. Secure the tray to the mounting surface using the
4 x fixings, supplied.
4. Place the large sealing ring into the groove on
the upper side of the Mounting tray.
5. Pull the SeaTalkng® cable through the mounting
surface hole and the Mounting tray. Plug in the
cable connector on the underside of the unit and
secure by rotating the locking collar clockwise
2 clicks.
6. Insert the unit into the mounting tray, ensuring
the tabs in the Mounting tray are slotted into the
grooves around the edge of the unit.
44
3.8 Selecting a location
Important:
The unit must be mounted with the LED 'arrow'
in parallel alignment with the longitudinal axis
(centerline) of the vessel and be pointing towards
the vessel's bow.
7. Place the Mounting trim over the unit slightly
offset, and then twist the Mounting trim clockwise
until it locks into position.

Bracket mounting the EV-1

The supplied Deck mounting kit is used to mount the
unit on a vertical surface.
Ensure that the chosen location meets the product's
location requirements, see
for details.
Important: The installation must only be
performed with the vessel either on a hard
standing, or tied-up alongside a pontoon or berth.
1. Use the Mounting bracket template (87170) to
drill 3 pilot holes in the vertical mounting surface.
Secure the mounting bracket to the surface using
the supplied screws.
3.8 Selecting a location