Table of Contents
Advertisement
HMI Display Operation and Identification
Start Center
F
. 8 Start Center Screen
IG
When the PR-Xv control box is powered on, select
'Start' in the 'Start Center' screen and the system
performs the self check.
If the displayer is connected, the system will perform
successful self check and display 'Automatic Main
Screen'.
If the displayer is disconnected, the system fails to
perform self check and stay on the self-check screen.
Press 'F8' or select
screens. Enter correct IP address to make the displayer
connected. For more information, see Software
update, page 45.
F
. 9 Self Check Screen
IG
20
to display displayer setting
Automatic Main Screen
F
. 10 Automatic Main Screen
IG
The content and functions of this screen are as follows:
Information bar
•
To illustrate the current status of equipment, such
as Auto-Standby or Auto-Shot dispense.
•
To show error information when an alarm is active.
Motor torque
To show the current motor torque. The torque of the
drive motor is shown in N•m. Select this to display
motor torque trend screen.
•
The A side: To show the current motor torque of
part A. Select to display Part A Torque Trend
Screen, page 24.
•
The B side: To show the current motor torque of
part B. Select to display Part B Torque Trend
Screen, page 24.
Pressure
Advertisement
Table of Contents
