Graco PR-Xv Instructions Manual page 33

Reload Setup Screen
F . 30 Reload Setup Screen
IG
On the Reload Setup Screen, press 'F1' or select
to display the System Main Screen. Press 'F7' or select
to return to the previous screen. Press 'F8' or
select to continue to the next screen.
The content and functions of this screen are as follows:
Reload pressure setup
Set the minimum pressure when reloading. If the
pressure does not reach the set 'Reload pressure low
limit' in the set 'Max reload time', the reload fails. The
system activates the alarm. If '0' is set, the reload
pressure monitoring function is disabled.
Maximum reload time setup
It is enabled when '0' is not set in 'Reload pressure low
limit'. If the pressure does not reach the set 'Reload
pressure low limit' in the set 'Max reload time', the
reload fails. The system activates the alarm.
HMI Display Operation and Identification
Reload request setup
When the piston reaches the set 'Reload request
position', the system sends out signal for reloading and
executes reloading command per the setup reload
type. Meanwhile, the system will not stop dispensing.
Reload completion setup
Set the target completed position of reload. For
example, if 80% is set to be the reload target, the
system finishes reloading when it is 80% full of the
maximum reload volume. Value of 95% is
recommended. The operator needs to adjust the value
per material viscosity and fluid pressure.
Reload rate setup
Set the reload rate of part A and B separately.
33