Standalone Operation; Updating Firmware - Bogen NQ-S1810CT-G2 Configuration Manual

Standalone Operation

This device can also run in Standalone Operation mode, where it will not interact with a
Nyquist server (e.g., E7000 or C4000). This means the device will not:
• Fetch device configuration from Nyquist server
• Register with Nyquist server (via SIP)
• Store backup information to Nyquist server
• Allow access to Nyquist server-based NTP
Standalone Operation allows this device it to be used without a Nyquist server as a
rd
generic SIP endpoint when integrated with a 3 -party VoIP telephone system or other
SIP server-based solutions, such as a unified communications (UC) platform. In a non-SIP
environment, these devices are capable of receiving audio through one or more priori-
tized multicast channels.

Updating Firmware

When you select Firmware Update from the appliance's web UI, the Firmware Update
page appears. From this page you can determine which Nyquist firmware version the
appliance is using and if an update is available. You can also load a firmware release,
install the loaded firmware, restore the configuration to factory defaults, and reboot the
appliance.
Note: A Nyquist appliance connected to the Nyquist network receives a configuration file
from the Nyquist server that includes the latest firmware available from the server. If the
firmware is different from the one installed on the appliance, an automatic firmware
update occurs unless the Firmware parameter for the station is left blank. Refer to the
Nyquist System Administrator Guide for more information.
5