Bogen NQ-S1810CT-G2 Configuration Manual page 13

The following table describes the
Table 5. Configuration Settings (Standalone disabled)
Get Configuration from
Server
Web Username
Emergency-All-Call
All-Call
Audio Distribution
Multicast #
Nyquist Control Password
The Configuration Settings
Station attached to the amplifier:
Port Number
Port Type
Configuration Settings
Retrieves configuration settings (i.e., web username,
server, and local port) from the TFTP server specified in
the Network Settings (see "Network Settings Tab
Parameters" on page 7).
Displays the username of the current user.
Identifies the IP address, port number, cut level (vol-
ume), and station list used for emergency all-call
pages.
Identifies the IP address, port number, cut level (vol-
ume), and station list used for all-call pages.
Identifies the IP address, port number, cut level (vol-
ume), and station list used for audio distribution.
Identifies the IP address, port number, cut level (vol-
ume), and station list used for the multicast audio
stream of a specific zone. If this device belongs to
more than one zone, then multiple
will be displayed.
Specifies a password used to secure Nyquist control
messages between this device and the Nyquist server.
This value must match the password specified on the
Nyquist server to support certain Nyquist features,
such as sound masking, amp protection mode, and sta-
tion check-in.
The specified password must be exactly 20 characters
long and include uppercase, lowercase, and numeric
characters.
Note: This password cannot be set unless the Web Password has
been changed from the default value.
tab also displays the following information for each
Identifies the port number of the appliance.
Identifies the station type to which the port connects.
tab settings:
Multicast # entries
Device
11