Bogen NQ-S1810CT-G2 Configuration Manual page 6

Standalone Operation
Volume Cut Level (dB)
The following buttons are available at the top of all pages in the application.
Dashboard
Configuration Settings
Network Settings
Firmware Update
Logs
DSP
Help
Manual
Logout
Table 1. Appliance Dashboard Fields
Enables or disables Standalone mode.
Specifies a temporary volume setting for the speaker
during the current intercom call or page.
Note: This is a temporary adjustment that allows the user to experi-
ment with the loudness of the speaker and will be reset to the nor-
mal setting on subsequent calls. To make permanent adjustments,
change the station-specific cut level settings on the Nyquist System
Controller.
The value can be adjusted between
Table 2. Appliance Dashboard Buttons
Displays the dashboard.
Accesses the Configuration Settings page where you can
view and set various options. If Standalone Operation is
not enabled, you can also receive configuration settings
from a Nyquist server.
Accesses the Network Settings page where you can view
and set network settings, such as the static IP address.
Accesses the Firmware Update page where you can view
the current Nyquist version, update firmware to a new
version, restore the configuration to factory defaults,
and reboot the appliance.
Accesses log files, which record either events or mes-
sages that occur when software runs and are used when
troubleshooting the appliance.
Accesses the DSP page where you can view and set
parameters for Digital Signal Processing (DSP).
Accesses the appliance's online help.
Displays this appliance's configuration guide.
Logs out of the appliance's web UI.
42 and 0 dB.
−
4