Bogen NQ-S1810CT-G2 Configuration Manual page 11

VLAN Priority
NTP Server
TFTP Server
TFTP Server from DHCP
DHCP Enabled
Reboot Appliance
Table 4. Network Settings (Continued)
Identifies the priority of the network traffic on the
VLAN. Priority can range from 0 through 7.
Identifies the IP address or the domain name of the
Network Time Protocol (NTP) Server.
Note: This field is only editable when Standalone Operation is
enabled.
Identifies the host name or IP address of the Trivial
File Transfer Protocol (TFTP) server.
The specified TFTP server can be used to automati-
cally set this device's Configuration settings via the
Get Configuration from Server button.
If TFTP Server from DHCP (see below) is set to "Yes",
this value will be auto-configured via DHCP option
66, assuming the DHCP server has been configured
to provide option 66. For details, see the documenta-
tion for your DHCP server.
Note: A TFTP server runs on the Nyquist server on port 69 (the
standard TFTP port) and the optional Nyquist DHCP service
automatically provides this TFTP address via option 66.
Note: If this value is unspecified, the TFTP Server from DHCP
will automatically be set to "Yes", this field will become read-
only, and DHCP will be used to configure this setting. To change
this value, the TFTP Server from DHCP setting must be set to
No, which makes the field editable.
Note: This setting is not available when Standalone Operation is
enabled.
"Yes" means the device will use the DHCP option 66
value to retrieve an address for the TFTP Server from
DHCP.
"No" means the device will ignore the DHCP
option 66 value and use the manually configured
value of the TFTP Server (see above).
Note: This setting is not available when Standalone Operation is
enabled.
Indicates if the device is enabled to use DHCP to
retrieve its IP configuration.
Indicates that this appliance should reboot when the
Save button is clicked.
9