Oven Shelves; Oven Light; Storage - Rangemaster Toledo 110 Dual Fuel Users Manual & Installation

Oven shelves

the shelf guard should be at the back pointing upwards
As well as the fl at shelves some models are supplied
with a drop shelf. The drop shelf increases the
possibilities for oven shelf spacing.
The oven shelves can be easily removed and refi tted.
Pull the shelf forward
until the back of the shelf
is stopped by the shelf
stop bumps in the oven
sides.
Lift up the front of the
shelf so the back of the
shelf will pass under the
shelf stop and then pull
the shelf forward.
To refi t the shelf, line up the shelf with a groove in the
oven side and push the shelf back until the ends hit
the shelf stop. Lift up the front so the shelf ends clear
the shelf stops, and then lower the front so that the
shelf is level and push it fully back.
Steam
When cooking foods with high water content (e.g.
oven chips) there may be some steam visible at the
grille at the rear of the hotplate. This is perfectly
normal.

Oven light

Press the appropriate button to turn on the
main oven light.
If the oven light fails, turn off the power
supply before you change the bulb. See the
'Troubleshooting' section for details on how
to change an oven light bulb.

Storage

The drawer can get very warm, don't store anything
in it that may melt or catch fi re.
The drawer can be removed completely for cleaning
etc.
To remove the drawer pull it forward.
For safety's sake push the drawer runners back out of
the way.
To refit the draw
Rest the drawer back on the side runners and,
keeping it level, push it right back. The clips should
click into position holding the drawer to the side
runners.
13
Lift up the ends
of the plastic clips
(one each side)
to release the
catches holding
the drawer to the
side runners and at
the same time pull
the drawer forward
and away from the
side runners.