Table of Contents
Advertisement
1
8 Eliminate malfunctions
K You can rectify minor faults in your device yourself. Take advantage of the
Troubleshooting information before contacting customer service. In this way
you avoid unnecessary costs.
WARNING
Risk of electric shock!
Improper repairs are dangerous.
Only trained specialists are allowed to carry out repairs on the device.
▶
Only original spare parts may be used to repair the device.
▶
If the power cord of this device is damaged, it must be replaced by the
▶
manufacturer, his customer service or a similarly qualified person in order to
avoid hazards.
disturbance
The display has
gone out and Begin/
Reload
"E: 30 / -80"
Cause and troubleshooting
Energy saving mode is active.
Press any key. a The display lights
▶
up again.
flashes.
The drain pipe or water drainage hose is blocked.
Clean the drain pipe and water drain hose.
▶
The drain pipe or water drainage hose is kinked or
pinched.
Make sure the drain pipe and water drain hose are
▶
not kinked or pinched.
The drain pump is blocked.
→
"Cleaning the drain pump ", page 40
▶
The water drainage hose is connected too high.
Install the water drainage hose at a maximum
▶
height of 1 meter.
Pump cover is not assembled correctly.
Assemble the pump cover correctly.
▶
Detergent dosage is too high.
Immediate measure: Mix a tablespoon of fabric
▶
softener with 0.5 liters of water and pour the
mixture into the left compartment (not for outdoor,
sportswear and down textiles).
For the next wash cycle with the same load, reduce
▶
the amount of detergent.
Inadmissible extension mounted on the water
drainage hose.
Troubleshooting de
43
Advertisement
Table of Contents
