de Troubleshooting
disturbance
Wrinkling.
Detergent or
Fabric softener is dripping off
the cuff and
collects on the door
or in the cuff.
Spin result is
not satisfied-
lend. The laundry is
too wet / too damp.
50
Cause and troubleshooting
Spin speed is too high.
Set a lower spin speed for the next wash cycle.
▶
Load is too high.
For the next wash cycle, reduce the load.
▶
Unsuitable program set for the type of fabric.
Select suitable programs for the type of textile.
▶
Too much detergent / fabric softener in the detergent
drawer.
When dispensing liquid detergent and fabric
▶
softener, pay attention to the marking in the
detergent drawer and do not dispense above it.
The low spin speed is set.
Set a higher spin speed for the next wash cycle.
▶
Start the program Fling.
▶
The drain pipe or water drainage hose is blocked.
Clean the drain pipe and water drain hose.
▶
The drain pipe or water drainage hose is kinked or
pinched.
Make sure the drain pipe and water drain hose are
▶
not kinked or pinched.
The unbalance control system has stopped spinning
due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Notice: Place large and small items of laundry
together in the drum. Laundry items of different sizes
are better distributed during spinning.
Start the program Fling.
▶
The unbalance control system compensates for unbalance
by reducing the spin speed.
Redistribute the laundry in the drum.
▶