Bosch WAX32MX2 Instructions For Use And Assembly page 45

disturbance
shines.
flashes.
All other error codes
of.
"E: 30 / -20"
Device works
not.
Program starts
not.
Cause and troubleshooting
Temperature is too high.
Wait until the temperature has dropped.
▶
→ "Abort program ", page 33
▶
The water level is too high.
Select a suitable program for expressing.
▶
→ "Programs ", page 26
Laundry is jammed in the door.
Open the door again.
1.
Remove jammed laundry.
2.
Close the door.
3.
To start the program, pressStart / reload
4th
Door is not closed.
Close the door.
1.
To start the program, pressStart / reload
2.
Malfunction
Call customer service.
▶
→
"Customer Service ", page 54
Solenoid valve defective.
Call customer service.
▶
→
"Customer Service ", page 54
Detergent dosage is too high.
For the next wash cycle with the same load, reduce
▶
the amount of detergent.
Filled in additional water.
Do not add additional water to the device during
▶
operation.
Mains plug of the power cord is not plugged in.
Connect the device to the mains.
▶
The fuse in the fuse box has tripped.
Check the fuse in the fuse box.
▶
Power supply has failed.
Check that the room lighting or other devices in
▶
the room are working.
Start / reload
Press Start / reload
▶
.
.
was not pressed.
Troubleshooting de
.
45