Table of Contents
Advertisement
de Set up and connect
4.3 Requirements for the
installation site
WARNING
Risk of electric shock!
The device contains live parts.
Touching live parts is dangerous.
▶
Do not operate the device without a
cover plate.
WARNING
Risk of injury!
The device can tip over when
operated on a base.
▶
Before putting the device into operation, it is
essential to secure the feet of the device on a
base with the retaining tabs → Page 30 of the
manufacturer.
CAUTION!
Freezing residual water in the
device can damage the device.
▶ Do not set up and operate the device
in areas where there is a risk of frost
or outdoors.
If the device is tilted more than 40 °,
residual water from the device can
leak and cause property damage.
Carefully tilt the device.
▶
▶
Transport the device in an upright position.
Installation site
base
14th
conditions
The device with
Retaining tabs
→
Page 30 loading
consolidate.
Installation site
Wooden beam ceiling
Kitchenette
On a wall
4.4 Remove the transport
locks
The device is secured for transport
with transport locks on the rear of
the device.
Notice: Keep the screws of the
transport locks and the sleeves for
later transport → Page 53 on.
conditions
Place the device
on a water
standing wooden
plate (thickness
at least 30 mm)
put up the
firmly to the floor
is screwed.
The device only
under through
walking working
set up the plate,
which are firmly
attached to the
ken connected
is. Required
Niche width:
60 cm.
No hoses
between wall
and device on
clamp.
Advertisement
Table of Contents
