de Troubleshooting
disturbance
"E: 30 / -80"
"E: 36 / -25 / -26"
"E: 38 / -25 / -26"
"E: 35 / -10"
44
Cause and troubleshooting
Remove impermissible extensions from the water
▶
drainage hose. Connect device
Pump cover is not screwed in completely.
Make sure that the pump cover is screwed into the
▶
device as far as it will go. The handle of the pump
cover must be vertical.
The drain pump is blocked.
→
"Cleaning the drain pump ", page 40
▶
The drain pump is blocked.
→
"Cleaning the drum ", page 38
▶
if the error is displayed again,
→
"Cleaning the drain pump ", page 40
▶
The inlet opening of the rubber boot is blocked.
→ "Clean the inlet opening in the rubber sleeve ",
▶
page 42
Water pressure is low. No
fix possible.
The filter in the water inlet is blocked.
Clean the sieve in the water inlet.
▶
The tap is closed.
Open the faucet.
▶
The water inlet hose is kinked or trapped.
Make sure that the water inlet hose is not kinked or
▶
pinched.
There is water in the bottom pan.
Turn off the faucet.
▶
Call customer service.
▶
→
"Customer Service ", page 54
Device is leaking.
Turn off the faucet.
▶
Call customer service.
▶
→
"Customer Service ", page 54
Detergent dosage is too high.
Immediate measure: Mix a tablespoon of fabric
▶
softener with 0.5 liters of water and pour the
mixture into the left compartment (not for outdoor,
sportswear and down textiles).
For the next wash cycle with the same load, reduce
▶
the amount of detergent.