disturbance
Detergent does not work
pumped out.
Water does not run in.
Detergent won't
washed in.
Repeated arrival
fling.
Program duration change
changes during the
washing process.
Cause and troubleshooting
is activated.
Continue the program by pressing fling or
▶
Pumping out choose and Start / reload
to press.
→
"Continuing the program at Rinse Hold ", page 34
The water drainage hose is connected too high.
Install the water drainage hose at a maximum
▶
height of 1 meter.
Pump cover is not assembled correctly.
Assemble the pump cover correctly.
▶
Detergent dosage is too high.
Immediate measure: Mix a tablespoon of fabric
▶
softener with 0.5 liters of water and pour the
mixture into the left compartment (not for outdoor,
sportswear and down textiles).
For the next wash cycle with the same load, reduce
▶
the amount of detergent.
Inadmissible extension mounted on the water
drainage hose.
Remove impermissible extensions from the water
▶
drainage hose. Connect device
Start / reload
Press Start / reload
▶
The filter in the water inlet is blocked.
Clean the sieve in the water inlet.
▶
The tap is closed.
Open the faucet.
▶
The water inlet hose is kinked or trapped.
Make sure that the water inlet hose is not kinked or
▶
pinched.
The unbalance control system compensates for the unbalance
by distributing the laundry several times.
No mistake - no action required.
▶
Notice: When loading, place large and small items of
laundry together in the drum. Laundry items of
different sizes are better distributed during spinning.
The program sequence is electronically optimized. This can
lead to a change in the program duration.
No mistake - no action required.
▶
Troubleshooting de
was not pressed.
.
47