Daikin R32 Sky-Air RZAG-M Service Manual page 82

ESIE17-08 | Part 3. Repair
3. Unplug the ground wires (6).
4. Unlock the 9 standoffs (8) that fix the electrical noise filter PCB.
5. Remove the electrical noise filter PCB (7) from the main PCB assembly.
8
1
7
6
2
8
1. Screw terminal
2. Connector
3. Screw terminal
4. Connector
Installation
I
NFORMATION
Replace all tie wraps that were cut during removal.
1. Proceed in reverse order.
PROCEDURE 3-PHASE
Removal
W : R
ARNING
When reconnecting a connector to the PCB, do not apply force, as this may damage the connector or connector pins of
the PCB.
1. Unplug the connector (2).
2. Unplug the terminal wires (1).
3. Unplug the 4 terminal wires (blue, black, red, white), fixed at the left side of the PCB, at the side of the main PCB.
4. Unplug the ground wire (3) at the side of the main PCB.
5. Remove the wiring from the cable clamps (6) if necessary.
6. Unlock the 4 standoffs (5) that fix the electrical noise PCB (4).
Page 82
R32 Sky-Air RZAG-M
Figure 3-16: Removing the electrical noise filter (1-phase)
F
ISK OF IRE
3.3. Unit specific repair procedures
5. Connector
6. Ground wire
7. Electrical noise filter PCB (1-phase)
8. Standoff
3
4
5
6
15/11/18 | Version 1.1