Appendix E Managing SMART Board MX series models using RS-232
Get command
get brightness
get volume
get mute
get fwversion
get serialnum
get partnum
get videofreeze
Note
This command is only available in
SMART Board MX firmware 1.8.7 or
later.
smarttech.com/kb/171555
Set command
set brightness[Value]
Where [Value] is one of the following:
+[Value]
l
-[Value]
l
=[5–100]
l
set volume[Value]
Where [Value] is one of the following:
+[Value]
l
-[Value]
l
=[0–100]
l
set mute[Value]
Where [Value] is one of the following:
=on
l
=off
l
N/A
N/A
N/A
set videofreeze=[Value]
Where [Value] is one of the following:
=on
l
=off
l
Note
This command is only available in
SMART Board MX firmware 1.8.7 or
later.
Response
brightness=[Value]
Where [Value] is a number between 5
and 100
Note
Enabling Auto Brightness overrides
any brightness values set manually.
volume=[Value]
Where [Value] is a number between 0
and 100
mute=[Value]
Where [Value] is one of the following:
on
l
off
l
fwversion=[Value]
Where [Value] is the firmware version.
serialnum=[Value]
Where [Value] is the display's serial
number.
Note
If multiple displays are connected, the
response includes the serial numbers
for all displays, separated by
commas.
partnum=[Value]
Where [Value] is the part number,
including the revision.
videofreeze=[Value]
Where [Value] is one of the following:
on
l
off
l
Note
This command is only available in
SMART Board MX firmware 1.8.7 or
later.
130