Smart Technologies SMART Board MX Pro Series Installation And Maintenance Manual page 119

Appendix D Managing SMART Board MX (V2), MX Pro (V2), and later series models using RS-232
Power state Description
STANDBY The screen is off, and the display is in a low power state. The display enters READY
or ON state when one of the following occurs:
This power state is the default energy saving mode for displays set to a non-EU
location.
Note
The EU uses "networked standby" to describe this power state.
POWERSAVE The screen is off, and the display is a very low power state. The display enters
READY or ON state when one of the following occurs:
This power state is the default energy saving mode for displays set to an EU
location.
Note
The EU uses "standby" to describe this power state.
UPDATEON The display is updating firmware. Do not turn off the display.
UPDATEREADY The display is updating firmware while the screen is off. Do not turn off the
display.
With the exception of get powerstate and set powerstate, commands are available only when the
display is in READY or ON power state.
smarttech.com/kb/171555
A user presses the Power button
l
control.
You send the set powerstate=standby command.
l
A user presses the Power button
l
control.
You send the set powerstate=ready or set powerstate=on command.
l
on the front control panel or the remote
on the front control panel or the remote
119