Honeywell ERX350 User Manual page 95

5 User Access
5.1 Getting Started with the Keypad
L2 main
Level 2
menu
ID Nr
categories
L2.10 RESET BATT
RESET
L2.11
COMMS
MODEM
L2.12
CALLS
L2.13
L2.14
L2.15
L2.16
To access level 2 mode:
1. Press and hold the ESC and UP arrow at the same time for about three seconds or until the Display
Test (all segments on) appears.
This unlocks the ERX350 keypad and ERX350 enters the HMI keypad mode.
2. Press OK to enter level 2 mode.
The level 1 mode PASSCODE screen appears.
3. To access the passkey screen, in level 2 mode press OK. The following appears on the display.
0000000
PASSCODE
For firmware versions before 1.0068, you must enter a five digit security code followed by a two
digit user ID code to enter level 2 mode. The default value for the level 2 passcode is 20000. The
Honeywell
2023
L2 main menu
L2 submenu as
as displayed
displayed on LCD
on LCD
Allows resetting the battery
gauge (assumes installing a new battery).
Resets Serial Comms – generally should not be needed.
Allows user to force an Alarm Call in to occur – assuming
ALARM CALL
proper configurations
Allows user to force a Scheduled Call in to occur –assuming
SCHED CALL
proper configurations
Allows user to cancel both Alarm and Scheduled Call retires
STOP CALLS
– Note: does not disable Call-in
BT PAIRING
BT PAIRING
UNPAIR BLE
YES /NO
Item code Description
87