4
SERVICE WORK
4.9
Folding the seat up
Main work
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the front wheel bearing.
–
Clean and grease the shaft seal rings
Long-life grease (
–
Insert the spacers.
C00734-11
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Operate the front brake lever several times until the brake linings are in contact
with the brake disc.
C00711-11
–
Remove the motorcycle from the lift stand.
–
Operate the front brake and compress the fork a few times firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Finishing work
–
Install the KTM PowerPack.
(Option: HV 2 technical personnel)
–
Perform an equipotential bonding check (KTM PowerPack installed).
(
p. 25)
–
Lock the seat.
–
Push the release lever
–
Lift the seat and fold it up.
C00805-10
and contact surface
p. 28)
.
.
(
p. 20)
(
p. 15)
in the direction of the arrow.
of the spacers.
M20x1.5
35 Nm
(25.8 lbf ft)
(
p. 11)
M8
15 Nm
(11.1 lbf ft)
14