Checking Residual Current Protection Switch; Recharging The Ktm Powerpack - KTM Freeride E-SX 2015 Setup Instructions

4 SERVICE WORK
Warning
Risk of injury There is a risk of electric shock if the battery charger or the cables have been manipulated or damaged.
The battery charger does not contain any parts which require maintenance.
–
Do not modify the battery charger or the cables.
–
Under no circumstances open the battery charger housing.
–
Do not insert any objects into the battery charger housing from the outside.
–
Do not use the battery charger if cables, plug or parts of the battery charger have been damaged or are soiled.
Info
The battery charger contains sensitive electronics and must be handled with appropriate care.
The battery charger may be damaged or destroyed if it is dropped, knocked or otherwise subject to mechanical overload.
When transporting the battery charger, ensure appropriate means of securing the cargo.
Damage caused due to improper handling or improper transport is excluded from the manufacturer warranty.
4.13

Checking residual current protection switch

4.14

Recharging the KTM PowerPack

Note
Material damage The power supply will be damaged in the event of an overload.
In charge mode Fast, a steady current of at least 13 A is required.
In charge mode Normal, a steady current of at least 10 A is required.
–
Ensure that the power outlet can supply the steady current required and is protected by a suitable fuse.
Warning
Environmental hazard A lithium-ion battery (KTM PowerPack) contains components and elements that are harmful to the envi-
ronment.
–
Never throw a KTM PowerPack into the household trash.
–
Dispose of the KTM PowerPack properly and in compliance with the applicable regulations.
–
Place the battery charger on a firm, level and horizontal surface.
–
Ensure the battery charger is adequately ventilated.
Guideline
Free space at the front and rear side of
the battery charger
–
Use the battery charger in the temperature range permitted.
Guideline
Ambient temperature
C00766-01
–
Ensure that the power plug for the battery charger always remains easily accessible.
Warning
Risk of injury There is a risk of electric shock with a faulty residual current
protection switch.
–
–
–
Connect the mains plug to the mains connection.
K00031-10
–
Press the
The operating display lights up red.
–
Press the
The operating display goes out.
–
Press the
The residual current protection switch can be used.
–
Disconnect the residual current protection switch from the mains connection.
Before each use of the charger check the residual current protection
switch.
Do not use the residual current protection switch if the test procedure
was not successful.

button.

button.

button.
20 cm (7.9 in)
−15... 50 °C (5... 122 °F)
16