KTM Freeride E-SX 2015 Setup Instructions page 10

3 SETUP
–
Mount the handlebar cushion.
M00697-01
–
Take off the electrical compartment.
–
Connect turn signal relay
–
Route the wiring harness for the rear turn signal and license plate lamp and
connect the electrical consumers.
–
Mount the electrical compartment.
C00868-10
–
Insert the black and violet cables of the bulb included in the separate enclosure
into the socket and position it in the turn signal indicator lamp
–
Position the turn signal on each side and mount and tighten nuts
–
Refit the headlight mask with the headlight.
M00698-10
–
Mount the footrests with the springs and pins. Secure the pins using the wash-
ers and cotter pins.
Pliers for footrest spring (58429083000)
M00695-01
–
Mount the license plate holder with the license plate lamp, turn signals, and
reflector.
–
Connect the electrical components.
M00699-01

.
Info
The cable of the left turn signal is marked red.
The cable of the right turn signal is marked green.

.

.
( p. 23)
8