Installation; Power Supply Requirements; Requirements - Graco Ex35 Installation Manual

Installation

Installation
Installation Installation
Installation of this equipment involves potentially
hazardous procedures. Only trained and qualified
personnel who have read and who understand
the information in this manual should install this
equipment.
NOTE: For complete Technical Specification
NOTE: NOTE:
information, see Driver Operation manual.
Power Supply Supply Requirements

Requirements

Power Power Supply Requirements
Improper wiring may cause electric shock or other
serious injury if work is not performed properly.
Have a qualified electrician perform any electrical
work. Be sure your installation complies with all
local codes and regulations.
See the table below for power supply requirements.
The driver requires a dedicated circuit protected with
a circuit breaker.
Model Model Model Voltage Voltage Voltage
24X901 200–240
Vac
NOTE: The protective earthing ground conductor
NOTE: NOTE:
must be equal to the phase conductions..
8
Phase Phase Phase Hz Hz Hz kVA kVA kVA
1 50/60 2.5
Hazardous Area Hazardous Hazardous Area Cabling Area
Requirements
Requirements Requirements
Explosion Proof Proof
Explosion Explosion Proof
All electrical wiring in the hazardous area must be
encased in Class I, Division I, Group D approved
explosion-proof conduit. Follow all National, State,
and Local electric codes.
A conduit seal is required within 18 in. (457
mm) of the driver for the US and Canada. See
Connect Power, page 10.
All cables must be rated 70°C minimum.
Flame Proof Flame Flame Proof (ATEX) Proof (ATEX) (ATEX)
Use appropriate conduit, connectors, and cable
glands rated for ATEX II 2 G. Follow all local codes
and regulations.
All cable glands and cables must be rated 70°C
minimum.
Cabling and Cabling and Conduit and Conduit Conduit
3A3165H