Power Button Board With Fingerprint Reader; Removing The Power Button Board Assembly With Fingerprint Reader - Dell P93F Service Manual

Steps
1. Connect the power button board FFC to the power button board.
2. Align and place the power button board with the power button FFC into its slot on the computer.
3. Replace the (M2x3) screw to secure the power button board to the computer.
4. Adhere the power button board FFC to the palmrest.
5. Connect the power button board FFC to the connector on the system board.
Next steps
1. Install the heat-sink assembly.
2. Install the battery.
3. Install the base cover.
4. Install the SD card.
5. Follow the procedure in

Power button board with fingerprint reader

Removing the power button board assembly with fingerprint reader

Prerequisites
1. Follow the procedure in
2. Remove the SD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the heat-sink
About this task
The figure indicates the location of the power button board assembly with fingerprint reader and provides a visual
representation of the removal procedure.
62 Removing and installing components
after working inside your
before working inside your
assembly.
computer.
computer.