Table of Contents
Advertisement
8. Install the
Nano-SIM card tray
9. Follow the procedure in
Power button with fingerprint-reader assembly
Removing the power button with fingerprint-reader assembly
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
Nano-SIM card
3. Remove the
base
cover.
4. Remove the
solid-state
5. Remove the
WWAN
card, if applicable.
6. Remove the
right
fan.
7. Remove the
left
fan.
8. Remove the
display
assembly.
9. Remove the
heat
sink.
10. Remove the battery.
11. Remove the
system
board.
About this task
The following images indicate the location of the power-button with fingerprint-reader assembly and provide a visual
representation of the removal procedure.
Figure 63. Removing the power button with fingerprint-reader assembly
if applicable.
after working inside your
before working inside your
tray.
drive.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
before working inside your
79
Advertisement
Table of Contents
