4. Tighten the (M2x3) screw to secure the WWAN card bracket to the system board.
Next steps
1. Install the
base
cover.
2. Install the
SD
card.
3. Follow the procedure in
Keyboard lattice
Removing the keyboard lattice
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
About this task
The figure indicates the location of the keyboard lattice and provides a visual representation of the removal procedure.
Steps
1. Using a plastic scribe, pry the top edge of the keyboard lattice starting from the recess points and working your way around
the sides and bottom edge.
2. Remove the keyboard lattice from the keyboard.
Installing the keyboard lattice
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
42
Removing and installing components
after working inside your
before working inside your
computer.
computer.