Shindaiwa DGK150DU Owner's Manual page 48

Electromagnetic Pump Filter element :
Electromagnetic Pump Gasket :
(9) Clean Strainer in Engine Feed Pump ( Fuel Suppuly Pump )
Clean
Remove eyebolts.
1
Remove strainer in eyebolts.
2
Clean the strainer with the compressed air and rinse it in the fuel oil and
3
reinstall in the reverse order.
< NOTE >
Put a tray under the lever in order to catch spilled fuel when loosing the lever.
Gaskets are attached to both ends of joint pipe. Be careful not to lose and install them in the
unit without fail.
Change both gauze filter and eyebolt when gauze filter is damaged.
Extract the air in fuel line after gauze filter washing finishes.
(Refer to "9-3. Procedures during Operation")
Ensure that there is no fuel leakage after reinstallation.
Engine Feed Pump Strainer :
PCV Filter
(Oil Separator)
ISUZU Part No.
898071-4010
ISUZU Part No.
898071-4040
Every 500 hours
ISUZU Part No.
898074-9550
Engine Feed Pump
(Fuel Suppuly Pump)
Oil Filler Cap
45
Joint Pipe
Eye Bolt
Engine Feed Pump
Eye Bolt
Strainer