Shindaiwa DGK150DU Owner's Manual page 36

Circuit Breaker
After starting the engine, remove your hand from the starter switch.
4
Keep the idling rpm for approximately 10 minutes.
5
Turn the throttle switch to RUN.
6
Adjust the voltage regulator dial to the specified voltage.
7
For three-phase load
For single-phase load
Turn the breakers to ON to start power transmission.
8
WARNING : ELECTRIC SHOCK/ / / / INJURY
Before turning the circuit breaker to ON position, ensure that the breaker or
the Switch of loads are positioned to OFF.
Operate the circuit breaker, well-communicating with the electrician by the
load side.
Voltage Adjust Regulator
60Hz 480V / 208V
60Hz 277V / 240V / 120V
33
Throttle Switch
Glow Lamp
Starter Switch