Shindaiwa DGK150DU Owner's Manual page 46

< NOTE >
After draining finishes, extract the air in fuel line.
(Refer to "9-3. Procedures during Operation")
(6) Cleaning / Changing Fuel Filter and Water Sedimenter
Clean
Replace
Loosen the air-bleeding plug.
1
Loosen the drain plug on the bottom to drain the fuel.
2
Remove the outer case of the filter using the specified
3
filter wrench.
Remove the fuel filter element and water sedimenter
4
element.
Install a new fuel filter element and water sedimenter element.
5
Replace the O-ring of the outer case.
6
Fill the case with clean fuel so that it is easy to bleed air from the fuel lines.
7
8 Tighten the outer case using the specified filter wrench.
Drain plug tightening torque: 1.5 to 2.5 Nm (0.15 to 0.25 kgfm / 1.1 to 1.8 lbf･ft )
Outer case tightening torque: 29.4 Nm (3.0 kgfm / 21.7 lbf･ft )
Air-bleeding plug tightening torque: 7.9 to 11.7 Nm (0.8 to 1.2 kgfm
< NOTE >
After replacing the filter, always air out the fuel system
(Refer to "9-3. Procedures during Operation")
Fuel filter element :
Water Sedimenter element :
Every 250 hours
Every 500 hours
ISUZU Part No.
898143-0410
ISUZU Part No.
898074-2880
43
Air-Bleeding Plug
Drain Plug
/ 5.8 to 8.6 lbf･ft )
Cup