Shindaiwa DGK150DU Owner's Manual page 34

■Replacing the Battery
< NOTE >
Two batteries are connected in series
order. Whenever you replace battery or
disconnect cables, always proceed with
the following steps, otherwise battery
may short-circuit.
(1) BATTERY - A
Remove the clamp and cable from negative (-) post from the battery on the
1
right side (always remove negative side first).
Remove the clamp and cable from positive (+) post from the battery on the
2
right side.
Remove the clamp and cable from negative (-) post from the battery on the left
3
side (always remove negative side first).
Remove the hold-down clamp from the battery on the left side.
4
Remove the clamp and cable from positive (+) post from the battery on the left
5
side.
6 Remove the left side battery from the seat.
※ ※ ※ ※ Reinstall the new battery in the reverse order.
(always install the cable to the positive (+) post of the new battery first)
(2) BATTERY - B
Remove the clamp and cable from negative (-) post from the battery on the
1
right side (always remove negative side first).
Remove the hold-down clamp from the battery on the right side.
2
Remove the clamp and cable from positive (+) post from the battery on the
3
right side.
Remove the right side battery from the seat.
4
※ ※ ※ ※ Reinstall the new battery in the reverse order (always install the cable to the
positive (+) post of the new battery first.
< NOTE >
Make sure that the removed cable does not come in contact with the battery post.
TERMINAL
Fixing Rod
BATTERY - A
31
TERMINAL
BATTERY - B